I just cleaned about 2 years of that stuff out, and the dryer now works like a charm. ULtimately, it will buildup around the filter and obstruct the flow, and cause heat to buildup. Everytime you clean the filter and put it back, you pack the lint below it down onto the inclined tray. However, the most common obstruction is under the removable filter (when you open the door). Fine lint gets through the filter and can accumulate on the outside vent and in the vent tube. Actually, it's about lint build up under the removable filter. If you wet a cloth and place it between the two bars you should get a reading on the ohmmeter. To check the sensor set your ohmmeter to a high ohms reading and check ohms across the connection to the sensor.
#Gx works 2 timer if reset is always on cracked#
I have seen the housing cracked between the bars if this is the case replace the housing. Locate the moisture sensor it is two bars running parallel inside the drum. Moisture sensor "tells" the control how much moisture is in the clothes and shuts the dryer off accordingly. This would be normal for some dryers if there were no clothes in the dryer or they were dry. I am thinking the control "thinks" the clothes are dry. It don't sound like it is overheating because it doesn't have at cool off to restart. Bad boards create all types of strange issues.ĭryer shuts off after being turned on anywhere froi 5-10 minutes after being turned on I can immediately turn it back on as it will do the same thing again it is a Frigidaire affinity front loader dryĭryer shuts off after being turned on anywhere from 5-10 minutes after being turned on I can immediately turn it back on as it will do the same thing again it is a Frigidaire affinity front loader dryer what do you think it could be. On the other options, it will stop when the clothes are dry.Ģ) A bad mother board - this could be a $200+ repair/replacement.
#Gx works 2 timer if reset is always on full#
If you set it to normal, it should run the full 50 minutes. Note: I have a Frigadaire Affinity and the button for the mode has less dry, normal, more dry options. If the clothes are dry, it is likely that your dryer is just running in DRYNESS mode and sensing your clothes are dry.
![gx works 2 timer if reset is always on gx works 2 timer if reset is always on](https://i.ytimg.com/vi/Fra7VMcNSvo/mqdefault.jpg)
When the dryer shuts off, compare the times and check the clothes. On a DRYNESS mode, set it and sync with another timer to the time the dryer states on the display (example: 50 minutes). If the time aligns, then you're probably good and maybe it was set to dryness mode before.
![gx works 2 timer if reset is always on gx works 2 timer if reset is always on](https://i.ytimg.com/vi/VFvpJ1TI0rc/maxresdefault.jpg)
To test this, try a TIME DRY mode and set it to the exact time you need and time it on another device like your phone. But if it is a smaller load, it may shut off in 10, 20 min or less than the noted time on the display. When you start the dryer, it may state the default time like 50 min. If your dryer starts right back up, then it's not likely an overheating issue as the relay would not allow the motor to start back up.ġ) Some dryers have a mode based on dryness like "less dry" or "more dry" and uses mist/moisture sensor to determine when to shut off. If your dryer does NOT start right back up, then it might be the motor overheating.